Windows 10

[ellysgifts]

Are there any changes necessary for the engraving software if we migrate to Windows 10?

thanks

[TimG]

If you do a seamless migration from Windows 7 to Windows 10, GravoStyle should continue to work as it always has. However, Windows 10 (and Windows 8 & 8.1) require signed drivers for the laser; you may need to update the laser driver to at least version 6.00, but that can be downloaded from the Files & Software area (be sure to run the setup.exe as Administrator). If you're moving from Windows 8 or 8.1 to 10 there should be no issues, as a signed driver is already installed. Still, Windows 10 has not been directly tested.
If you should need to do a fresh install of GravoStyle on any version of Windows higher than 7 you will have to be sure to run the Setup.exe with compatibility mode set to "Windows 7" to install correctly. Again, running GravoStyle itself should be just fine.

Tim