Laser fault

[Bill]

Twice while engraving the wooden puzzle, during the second time is started the engraving and while the table was going down, I got a Laser fault error and the process stoped. I was not sure the best way to get engraving started, so I turned the laser off, then back on and sent the file again. The job worked properly then. Is there another way to remove the error message and restart the job from the beginning?

[TimG]

The "04 LASER FAULT" error can only be reliably cleared/reset by powering the machine off, back on, and re-sending the job. If you get this error with increasing frequency (or simply on a wide variety of files), please let me know.

Tim

[Bill]

I did 4 wooden puzzle on Saturday and each time when I hit the green button to do the second item, I got the error. I reset, and it worked fine. This is the only item I have ever gotten the error on.