ZKMC01 alignment off

[joybooks]

We did one of these yesterday and it lasered way too high. I didn't know if it was just me or if there is a problem with the file. - Loreen

[TimG]

There doesn't appear to be a problem with that file and I haven't had any other reports. I you're not having trouble with running other pieces, I'd suggest rescanning the file from the book and running a red light (the red box on layer 2 would be fine) with the unmodified file. If the unmodified file is fine, then I'm not sure what happened. If there's still something wrong, please call me at 800-828-5260.